@article { author = {Tabesh, Massoud and Kazemi Soochelmaei, Mohammad}, title = {Studying the Effect of Factors Influencing the Change in Hazen-Williams Roughness Coefficient of Cast Iron Pipes during Operation Period}, journal = {Journal of Water and Wastewater Science and Engineering}, volume = {3}, number = {2}, pages = {23-34}, year = {2018}, publisher = {}, issn = {2588-3941}, eissn = {2588-395X}, doi = {10.22112/jwwse.2018.129924.1089}, abstract = {Considering the importance of sufficient pressure in supplying demand in water distribution networks, it is necessary to study the factors affecting pressure variation, that the roughness of pipes directly affects the pressure of nodes. Therefore, the study of factors affecting the change in roughness coefficient (Hasen-Williams) in water distribution networks is important. Pipes diameter, age and corrosion are among factors affecting the change in the roughness coefficient of pipes that are evaluated in this paper. The roughness coefficients were plotted against each of the above mentioned factors, and the approximate relations of the roughness coefficient was obtained by fitting to the obtained graphs. Finally, by combining the relations obtained, a general relation is obtained for the roughness coefficient. Also, in this paper, the cast iron pipes, for which laboratory data is available, were used to obtain a mathematical relationship.Then again, instead of using the roughness coefficient of new pipes in analysis and design, the roughness coefficient for the end of the design period was used, taking into account the effective factors mentioned.To evaluate the results of the proposed method, a two-loop network was investigated in two common and real situations. The results showed that if the roughness coefficient of new pipes at the end of design period is used for designing, there will be a save of about 50% in cost of pipes, but then the network pressure at the end of design period will be reduced by more than 25%. Therefore, in order to ensure that there is sufficient pressure and demand satisfaction throughout the design period, it is necessary to accept an increase in the cost of network implementation at the beginning of the project.}, keywords = {Consumption,corrosion,Hazen-Williams roughness coefficient,Pipe age,Pipe diameter,pressure}, title_fa = {بررسی تأثیر عوامل مؤثر بر تغییر ضریب زبری هیزن - ویلیامز لوله‌های چدنی در طول دوره بهره‌برداری}, abstract_fa = {با توجه به اهمیت فشار کافی در تأمین تقاضای مصرف­کنندگان در شبکه­های توزیع آب، بررسی عوامل مؤثر بر تغییر فشار ضرورت می­یابد که زبری لوله­ها به‏صورت مستقیم بر روی فشار گره­ها تأثیرگذارند. بنابراین بررسی عوامل مؤثر بر تغییر ضریب زبری (ضریب هیزن-ویلیامز) در شبکه­های آب اهمیت پیدا می­کند. قطر لوله­ها، عمر لوله­ها و خورندگی آب از جمله عوامل مؤثر در تغییر ضریب زبری لوله­ها هستند که در این مقاله مورد ارزیابی قرار می­گیرند. تغییرات ضریب زبری با هرکدام از عوامل مذکور رسم می­شود و با برازش نمودارهای حاصله می­توان روابط تقریبی ضریب زبری را به‏دست آورد. در نهایت با ترکیب روابط به­ دست آمده، یک رابطه کلی برای ضریب زبری حاصل می­شود. همچنین در این مقاله از لوله­های چدنی که داده­های آزمایشگاهی آن در اختیار است، برای به­دست آوردن رابطه ریاضی استفاده می­شود. با وجود این، به جای استفاده از ضریب زبری لوله­های نو در تحلیل و طراحی از ضریب زبری در انتهای دوره طرح با درنظر گرفتن عوامل مؤثر مذکور استفاده خواهد شد. برای ارزیابی نتایج روش ارائه­ شده، شبکه دوحلقه­ای در دو حالت معمول و واقعی مورد بررسی قرار می­گیرد. نتایج نشان می­دهد اگر برای طراحی از ضریب زبری لوله­های نو استفاده شود، فشار شبکه در انتهای دوره طرح بیش از 25 درصد کاهش می­یابد ولی در هزینه لوله­ها در ابتدای دوره طرح حدود 50 درصد صرفه­ جویی می‌شود. بنابراین برای تضمین وجود فشار کافی و ارضای تقاضا در انتهای دوره طرح باید افزایش هزینه اجرای شبکه در ابتدای دوره طرح را پذیرفت.}, keywords_fa = {ضریب زبری هیزن - ویلیامز,قطر لوله,عمر لوله,خورندگی آب,مصرف,فشار}, url = {https://www.jwwse.ir/article_82089.html}, eprint = {https://www.jwwse.ir/article_82089_54ee06ca8574bbbd9920d808cd11ef60.pdf} }